Kev,
Yes, common mode current can be a problem on receive as well as transmit.
Transmit will cause RF-in-the-shack which is more obvious because you
can be 'bitten' by RF. On receive, the common mode current will result
in added receive noise due to pickup of noise on the transmission line.
OCF antennas are notorious for common mode currents as are end feds. A
balanced antenna is usually easier to tame, but are not immune.
For effective common mode chokes (some call them baluns or in-line
isolators), review the papers of K9YC Jim Brown on the subject. He has
posted many times on this reflector - bottom line is that many baluns
and in-line isolators are not very effective, how much so depends on the
frequency and the core material used.
In addition, if your antenna feedline does not run perpendicular to the
antenna for at least 1/4 wavelength, it can pick up currents from the
radiator. Yes, transmit is more extreme, but it happens in receive as
well. Antennas and transmission lines are bi-lateral devices, so what
happens in transmit happens in reverse on receive. The transmit effects
are easier to measure because the signals are larger.
As for the power supply itself, heed the information provided by Howie
Hoyt in this thread - he has done extensive testing in his development
of the PAE Kx33 power supply.
73,
Don W3FPR
On 7/15/2016 5:01 PM, Kevin - K4VD wrote:
Thanks Dick and Howard...
The RS-50 is pretty new - maybe 6 months old and is in daily use. It wasn't
until I had a rig I could easily run on batteries did I notice the noise.
The RS-12 is quite old, maybe 15 years? It had been in storage about 10
years until trying it out today. I think I need to dig into the RS-50 and
just make sure everything is soldered and connected well.
As for common mode currents in the antenna... would that only be an issue
during transmit? I have an OCF so I know it can be an issue on transmit.
The OCF has a 1:1 current BALUN in the center. Is that enough or do I need
to add some additional choking just below the BALUN? I have a couple of the
NI4L line isolators (http://www.ni4l.com/hf-choke-line-isolator-1-8-300-mhz/).
I could put one up there and see what it does. I also have plenty of
clip-ons laying around. I'll try them on the power lead from the supply to
the radio.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
