Well I think so too. So one step forward and one step back. Got it working.
Was a bad solder joint. Sure looked good but did not test out with the meter
! Some of those caps are in rather tight spots :)
So the "last" step back was during reassembly. The center connector on the
RF cable where it solders to the 100watt board broke loose. That looks like
its gonna be a little work. Cant get at the side of the board I need without
taking it apart. Dont think anyway. Back to soldering.
Thanks Don. All is good now. This 2.6 should sound a LOT different than the
2.1. Hope so anyway.
73,
Rich
----- Original Message -----
From: "Don Wilhelm" <[EMAIL PROTECTED]>
To: "Rich McCabe" <[EMAIL PROTECTED]>; <[EMAIL PROTECTED]>;
<[email protected]>
Sent: Thursday, March 09, 2006 9:44 PM
Subject: RE: [Elecraft] K2 SSB
Yes, that is entirely possible, and in your case it looks like that is the
situation.
73,
Don W3FPR
-----Original Message-----
I thought they came at the same time? So its possible to have the "-s"
crystals in a 2.1 khz setup?
Rich
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
