Rich, Use Spectrogram and center that 2.6 passband between 300 Hz and 2900 Hz and you should be good to go. I would say to bite the bullet and remove the KPA100 board to fix the cable - trying to solder it with the board in place is an exercise in frustration that usually ends in failure (been there, tried that - never successfully 'done that').
73, Don W3FPR > -----Original Message----- > > Well I think so too. So one step forward and one step back. Got > it working. > Was a bad solder joint. Sure looked good but did not test out > with the meter > ! Some of those caps are in rather tight spots :) > > So the "last" step back was during reassembly. The center > connector on the > RF cable where it solders to the 100watt board broke loose. That > looks like > its gonna be a little work. Cant get at the side of the board I > need without > taking it apart. Dont think anyway. Back to soldering. > > Thanks Don. All is good now. This 2.6 should sound a LOT > different than the > 2.1. Hope so anyway. > > 73, > > Rich > > > ----- Original Message ----- > From: "Don Wilhelm" <[EMAIL PROTECTED]> > To: "Rich McCabe" <[EMAIL PROTECTED]>; <[EMAIL PROTECTED]>; > <[email protected]> > Sent: Thursday, March 09, 2006 9:44 PM > Subject: RE: [Elecraft] K2 SSB > > > > Yes, that is entirely possible, and in your case it looks like > that is the > > situation. > > > > 73, > > Don W3FPR > > > >> -----Original Message----- > >> > >> I thought they came at the same time? So its possible to have the "-s" > >> crystals in a 2.1 khz setup? > >> > >> Rich > >> > > > > > > _______________________________________________ > Elecraft mailing list > Post to: [email protected] > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com > > > -- > No virus found in this incoming message. > Checked by AVG Free Edition. > Version: 7.1.375 / Virus Database: 268.2.1/277 - Release Date: 3/8/2006 > > _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
