K3 or K3s?
On 7/26/16 5:48 PM, Chris Kimball wrote:
I'm a new owner and all worked fine. After an absence of a few days I came
back to no power out, or , at least, very little.
Rig is the 100W version with ATU working into a dummy load. In CW mode
adjusting the power level to 70W produces only a one segment power out.
Running the ATU produces a 5W indication, the usual searching rumbling, but
no resultant SWR. The Test mode is NOT in operation.
I have restored to the last working config via K3 Utility, but suspect I
must have "hit" something to limit the power. The FP and AMP temps were too
high (35C) when the problem was noticed. I set them down to a more
reasonable 23C without effect. Input voltage is 12.8V.
Probably something trivial, but suggestions would be appreciated.
Chris
NQ8Z
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
