>Pay very close attention to the screw lengths and sort them out
carefully...
>later you may need the 3/16" and the 1/4" is tooo long :)
Amen to that, brother!
After 50+ years of building radios, I built my K3 very carefully.
However, on completion, the output was very intermittent. Tapping on the
cabinet would trigger the problem. I tried everything, including on line
and on-the-phone discussions with the Elcraft service dept.
Finally, I boxed it up and sent it to the doctor.
They diagnosed the problem right out of the box, with no tools.
I had placed two lockwashers on the wrong end of the screws holding the
driver transistors to the bottom of the case, so they made only
intermittent contact. Bingo! Was my face red!
The moral of the story: be careful, and check EVERYTHING during assembly.
VE7XF
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
