At one time there was a paper on the web page written by either Wayne or Eric ( I can't remember which) that had recommendations on filter selection. You might try and find it or get the author to republish.

73,
Barry
K3NDM

------ Original Message ------
From: "Jim Brown" <[email protected]>
To: [email protected]
Sent: 9/1/2016 2:47:40 PM
Subject: Re: [Elecraft] Recommended filters for Diversity Receive?

On Thu,9/1/2016 10:19 AM, [email protected] wrote:
My primary usage will be SSB and CW contesting, and very occasional SSB and CW DXing.

My ears find a 1.8 kHz roofing filter too narrow for SSB, preferring 2.1 kHz. The DSP IF can always be set narrower if desired.

I first bought 400 Hz 8-pole CW filters and later 250 Hz 8-pole. I nearly always use the 250 Hz filter on CW. I only use the 400 Hz filter for RTTY.

Diversity is VERY useful on 160, 80, 40, and even 30M. I find that I nearly always use diversity to pull out seak signals, so I have only put the narrowest filters in the second RX.

Diversity is useful in several ways. First, to overcome selective fading -- that simply requires antennas spatially separated from each other. Second, for multiple directivities, both vertical and horizontally. My second RX is usually connected to a Beverage.

73, Jim K9YC

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]

Reply via email to