I bought a pile of these at $20 US each. http://www.digital-loggers.com/iot.html
I drive them with PI's or just about anything. It takes any logic from +3V to 120Vac to control them. I found that all the other options are great, but very very expensive for what they are. Mike va3mw On Tue, Sep 13, 2016 at 12:38 PM, iain macdonnell - N6ML <[email protected]> wrote: > On Tue, Sep 13, 2016 at 8:04 AM, Jim Miller <[email protected]> wrote: > > For those of you implementing remote operation: what are you using for an > > IP accessed power switch? I need one port to control station A/C power > and > > another to toggle the K3s power control line on the ACC connector. > > I use an old ("telnet" interface) WTI Network Power Switch that I > rescued from a recycle pile. Digital Loggers Inc make a > good/inexpensive "Web Power Switch". > > For powering-on the K3 via ACC pin 8, I use a RS232 port on an onsite > PC, with the same simple circuit used for FSK keying. > > 73, > > ~iain / N6ML > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
