In DXLab, when I click on RTTY DX spot in SpotCollector the K3 changes the frequency in the K3 but it's 850 Hz higher than the frequency that DXLab sends to the radio. I'm using K3 FSK D with 1275/1445 tones, NOT AFSK.
An 850 Hz offset *sounds like* either your K3 or WinWarbler has been reset to 2125/2295 Hz. *CHECK BOTH* "Pitch" in the K3 and "Mark Offset"/"Optimal Offset" in the FSK panel of WinWarbler's Configuration dialog.
I don't know if my other problem is attributable to the firmware either. DXLab's rig control module, Commander, has a nice feature (activated by clicking on a button in the VFO B panel) that will switch the radio to split and turn on the subreceiver (called "dual receive" in Commander). It used to do both of those but now only turns on split but not the subreceiver.
I've used DXLab Suite (Commander) for years with the K3 and do not know what button in the VFO B panel to which you refer. There are *two* check boxes in the VFO A panel - one turns split on/off (equivalent to holding A -> B on the K3 front panel) and the other turns the Sub RX on/Off (equivalent to tapping Sub on the K3 front panel). I'm using FW 5.52 at present and all radio control features of DXLab Suite work just the same as they have in prior versions of the K3 firmware. 73, ... Joe, W4TV On 10/1/2016 12:33 AM, Jim McDonald wrote:
I installed K3 FW 5.50 to use my K-Pod, which I like very much. I have a couple of weird problems using DXLab now that I can't explain and wonder if the new FW might be related. In DXLab, when I click on RTTY DX spot in SpotCollector the K3 changes the frequency in the K3 but it's 850 Hz higher than the frequency that DXLab sends to the radio. I'm using K3 FSK D with 1275/1445 tones, NOT AFSK. I don't know if my other problem is attributable to the firmware either. DXLab's rig control module, Commander, has a nice feature (activated by clicking on a button in the VFO B panel) that will switch the radio to split and turn on the subreceiver (called "dual receive" in Commander). It used to do both of those but now only turns on split but not the subreceiver. I'd very much appreciate someone also using FW 5.50 and DXLab would check to see if my experience is unique to me or not. Thanks. 73, Jim N7US ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected]
______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
