Make sure all of the plugs are fully seated in their sockets. 73,
Fred KE7X For all KE7X Elecraft books, see www.ke7x.com ________________________________ From: Elecraft <[email protected]> on behalf of Ryan Noguchi via Elecraft <[email protected]> Sent: Friday, December 30, 2016 8:38 AM To: [email protected]; [email protected] Subject: Re: [Elecraft] KXPA100 with PX3 >>http://www.elecraft.com/manual/PX3_installation_FAQ_v-0-8.pdf see Figure 3. >When I tried that, I got no output from the KXPA100 with the KX3 PA MODE set >to ON. If I set that to OFF, I get full output but then not full interaction >with the KX3. What am I doing wrong? So are you saying that you have the KX3, PX3, and KXPA100 all connected in the exact manner depicted in Figure 3 (which also appears in the PX3 manual) and you're still experiencing this problem? Maybe I'm mistaken, but it sounds like you aren't using the KX3-KXPA100 adapter cable. You can't just connect the KXPA100 RS232 port directly to the KX3 ACC1 port. 73, Ryan AI6DO ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
