Further to my last email, when I am in Basic mode, with PA MODE set to OFF and 
the KXPA100 on/off switch set to ON, I get full power out and no dissipation.  
When PA MODE is ON and the on/off switch set to OFF, the KX3 acts like the 
KXPA100 is connected to it but there is no power output from the KXPA100 but 
all the power it produces is being dissipated.  Some setting is probably wrong, 
but I can't figure out which one.


Any ideas?


73 Ray W2RS



-----Original Message-----
From: Dave AD6A <[email protected]>with
To: donwilh <[email protected]>
Cc: rsoifer1 <[email protected]>; fcady <[email protected]>; ai6do 
<[email protected]>; elecraft <[email protected]>
Sent: Fri, Dec 30, 2016 10:39 am
Subject: Re: [Elecraft] KXPA100 with PX3

You may simply have the power set too low (below 11W) for the KXPA100 to turn 
on. 

73 Dave AD6A

Sent from my  iPhone 5s

> On Dec 30, 2016, at 9:22 AM, Don Wilhelm <[email protected]> wrote:
> 
> Ray,
> 
> Check to be certain the RJ-45 connectors are fully plugged in.  Some of them 
> are difficult to seat if you hold onto the cover boot.  Pull the boot back 
> and push the plug itself in until it clicks.
> 
> Make sure the other plugs are fully seated - give them an extra push into 
> their jacks.
> 
> 73,
> Don W3FPR
> 
>> On 12/30/2016 11:50 AM, Ray W2RS via Elecraft wrote:
>> The KX3 says it has the KXPA100 behind it, but I still get no output.  When 
>> I turn PA MODE to OFF, and turn the amp ON using the front panel switch, I 
>> get full output but in Basic mode.
>> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:[email protected]
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to [email protected]


______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]

Reply via email to