Sometimes I have found that when starting FlDigi, the cat linkage doesn't work on FLDigi's start-up. I then have to go to FLDigi's menu and do the following: Configure-->Rig Control-->RigCat tab --> Initialize button. If the button doesn't turn red, you should be able to see changes on the rig or on FLDigi sync'ed between the rig and FLDigi.
HNY, Brian VE3IBW / CG3IBW On Sun, Jan 1, 2017 at 11:25 AM, George Kidder <[email protected]> wrote: > Hi Brian, > > Thanks for the reply. I had found that "howto" file, but can't make much > sense of it. The current K3.xml file relays changes between the rig and > the two little blue boxes under the frequency display, but these changes > are not reflected in the fldigi operate mode, nor do changes in the op mode > result in changes in the K3. Nor do the changes in these little boxes get > reflected in the log entry, which is very annoying. > > So do your modifications correct these problems? If so, could I have a > copy of it. > > 73 and Happy New Year, > > George > > > > On 1/1/2017 10:37 AM, Brian Waterworth wrote: > >> Yes, I have had success with my KX3 and FlDigi by modifying the rig xml >> for >> the K3 as a starting point. Here is the howto: >> http://www.w1hkj.com/FldigiHelp/rig_xml_page.html >> >> It took me a little longer to figure out the xml file's relationships, but >> this howto didn't exist then. >> >> Once you see the linkages among the various XML elements, you will be >> changing the k3.xml file with ease. >> >> Have fun !! >> >> regards, >> Brian >> VE3IBW / CG3IBW >> Canada's Sesquicentennial (https://wp.rac.ca/special-event-canada150/) >> >> >> On Sun, Jan 1, 2017 at 10:02 AM, George Kidder <[email protected]> wrote: >> >> Hi gang, >>> I am running fldigi with my K3, and everything works as indicated in the >>> manual. It would be useful if fldigi was able to poll the K3 for mode >>> information, and set itself accordingly. I suspect that a modification >>> of >>> the K3.xml file might accomplish this, but I don't know enough about the >>> programming to see where. >>> >>> Has anyone succeeded in getting mode information from the K3 to fldigi? >>> >>> Thanks, >>> George, W3HBM >>> >>> ______________________________________________________________ >>> Elecraft mailing list >>> Home: http://mailman.qth.net/mailman/listinfo/elecraft >>> Help: http://mailman.qth.net/mmfaq.htm >>> Post: mailto:[email protected] >>> >>> This list hosted by: http://www.qsl.net >>> Please help support this email list: http://www.qsl.net/donate.html >>> Message delivered to [email protected] >>> >>> > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
