I had the same issue with HRD and it was the USB serial adapter. The one I was using had a transfer speed of 115 mbps which apparently wasn't sufficient. Bought a Keyspan adapter with a transfer rate of 220 mbps and all works well. I did have to go into the device manager and make a few changes to the port settings for the Keyspan.
Saw an Iogear adapter at WalMart for I think it was $29.00 that had a transfer rate of 200 mbps and appear to work well from accounts I've read. 73, Ed N0EHQ > I recently completed my K2. I assume that it has the very latest > firmware. Although it works fine with k2Remote, it doesn't work reliably > with any third-party software that I've tried. I've tried the latest > version of dxLab commander, HamRadioDelux, and even purchased > HamStationExtreme. Comander won't even connect with the K2. HRD keeps > stalling when updating the frequency display. The current release of HSE > doesn't appear to work. I'm waiting for an update. > > As far as I can tell from research I've been able to do, there are > firmware problems in the K2 that make the interface unreliable. Elecraft > says they don't have any room in their program space to add any flow > control. Does anyone have any information about this problem or comments > about other control software? > > Regards > Rich - KE1EV > _______________________________________________ > Elecraft mailing list > Post to: [email protected] > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com > _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
