Randy,
That scope has a sensitivity of 2mV per division on the most sensitive
setting. That is 2000uV per division. The 50uV output of the XG2 would
show up as only 1/40th of a division on your 'scope - that may not be
enough to discern easily.
If you are using a 10X probe then the XG2 output would be only 1/400th
of a division - very difficult to see.
73,
Don W3FPR
On 5/9/2017 1:49 PM, Randy Moore wrote:
I have a trusty Elecraft XG2 S9 Signal Generator that I've used for
years. It produces a nice S9 signal into my K3 at 7040.3 KHz. I'm
trying to use it for trouble shooting a problem on a transceiver kit and
there's something that I don't understand. When I try to measure the 50
uV (S9) signal with a Siglent SDS 1102 CML scope, I get nothing (no
signal). I've tried it with the XG2 antenna connector open, and with it
connected to a good 50 ohm dummy load.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
