Just a quick thought, are you using a 10:1 probe? If so, you would only be getting 5 uV to the scope.
Harlan K4HES Sent from my iPhone > On May 9, 2017, at 1:49 PM, Randy Moore <wrmoor...@gmail.com> wrote: > > I have a trusty Elecraft XG2 S9 Signal Generator that I've used for years. It > produces a nice S9 signal into my K3 at 7040.3 KHz. I'm trying to use it for > trouble shooting a problem on a transceiver kit and there's something that I > don't understand. When I try to measure the 50 uV (S9) signal with a Siglent > SDS 1102 CML scope, I get nothing (no signal). I've tried it with the XG2 > antenna connector open, and with it connected to a good 50 ohm dummy load. > I'm measuring at the XG2 antenna connector (center conductor) with the scope > probe grounded on the large 50 uV/1 uV switch which is grounded to the XG2 > circuit board ground. > > I'm able to measure other signals of about the same amplitude and frequency. > > Are my expectations wrong, or am I doing something wrong??? > > 73, > Randy, KS4L > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to hsherr...@reagan.com ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com