Yes. The DSP board for the sub-rec is installed on the front panel. I too used to dread removing the panel but after the second time, it's no big deal. It is just a case of being careful when re-assembling.
Sent from my iPhone ...nr4c. bill On May 12, 2017, at 8:34 AM, Irwin Darack <[email protected]> wrote: >> From everyone's comments, I realize that to have dual watch ( listen to two > different frequency on the same band) on my K3s, I need to install the KRX3A > sub-receiver. I have two K3s that I have built, one with the KRX3A and the > second without. I am thinking of upgrading the second one with the > sub-receiver now. > > To install a KRX3A in an already built K3s do I need to remove the front > panel? I am hoping that I do not as to reinstall the front panel you have > to be very careful not to bend a pin. I realize that I have to install some > new additional stand-offs on the main RF board. I have reviewed the KRX3A > install instructions and it's a little confusing on the difference in a > older K3 versus a K3s. It appears that you have to take the front panel > totally apart? > > Looking forward to see everyone at Dayton (Xenia). > > Thanks, Irwin KD3TB > -- > Irwin KD3TB > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
