Hi Ron.
That and banging on it with a rubber mallet are valid percussive
maintenance techniques.
73,
Bob
K2TK
On 7/2/2017 6:24 PM, Ron D'Eau Claire wrote:
If it was mine, I'd start by dropping it onto the operating desk from a
height of about 6 inches, onto the bottom feet and, if that didn't make it
quit, onto the side feet.
I presume the cables you checked were external to the K3. There are a number
of coaxial cables with TMP connectors around the synthesizer and reference
oscillator boards the might be loose since they are simple friction fit
connectors.
IF it is a K3/100, be sure the KPA3 amplifier module is fully seated and the
screws are in place.
73, Ron AC7AC
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
