This is similar to the fellow who tells his doctor, "It hurts when I do
this." Doctor replies, "Don't do that. Fifty bucks, pay on the way
out." In your case, your K3 doesn't like FD, "don't do that." [:-)
Seriously, with that low a serial # [mine is 642], strange things can
and do happen. I took mine to Pershing County NV for the 7QP. It worked
fine. When I got back home, it didn't and I was really carefulpacking it
into the truck. Based on an almost countable infinity of previous posts
here over the years, I pulled and reseated the front panel, and made
sure all the TMP connectors were fully seated. Now it works like its
old self. Your symptoms are a little different... it doesn't like FD
... and it works now, but you might give that a try and then wait til
the end of June 2018 to see if it fixed the problem[s].
Some of the switches on mine are getting a bit unreliable, sometimes
BAND DOWN disables the ATU. Wife has a needlepoint hobby which is every
bit as expensive as ham radio, at least at my level[my stuff is more
expensive, but she buys A LOT more of hers than I do mine, and then she
pays to have Ian frame it]. We have an "Equal Hobby Allowance" policy,
I'm waaay ahead in my account, I may sell may at a real discount to some
young new ham who needs a radio and get a shiny new K3s.
73,
Fred ("Skip") K6DGW
Sparks NV USA
Washoe County DM09dn
On 6/29/2017 8:49 AM, Nr4c wrote:
My K3 (s/n 453x) has been used for FD and other outdoor events plus use at home (till I
rec'd one of the first K3Ss). On at least 2 events in past year it has exhibited little
output power. Batteries were checked, cables checked and replaced, to no avail. Display
did not show SWR when TUNE button pressed (only "--"). Another K3 was swapped
in and everything was fine.
I took radio home and it worked perfectly.
This year at FD, it quit at around midnight. Even tried <12 W to verify LPA.
Result little or almost no power. Checked LPA screws but they were tight. Voltage
on radio was just above 12v on TX. Took it home and it shows no sign of low power.
It has worked well all week.
Reloaded FW from Elecraft and reloaded last CONFIG file (May 2017 just before
first event of year and did TX cal at this time).
Now hooked to dummy load and running stress test with FD CW msg on repeat.
Anyone have ideas?
Sent from my iPhone
...nr4c. bill
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
--
This message has been scanned by E.F.A. Project and is believed to be clean.
---
This email has been checked for viruses by AVG.
http://www.avg.com
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
