Today I went about upgrading my K3S with the KBPF3 board and a 6khz filter. I moved all my filters down one slot and put the 6khz filter in the first slot. I installed the KBPF3 board, turned it on in the config etc.
I then went to the K3 utility and configured my filters, all seemed to go well. I turned the radio on after connecting all the cables and the pan adapter does not show any signals. It is getting frequency information and changes as I move the dial. I have the cable connected into IF OUT on the radio and IF IN on the P3, and I have tried both of the serial cables that came with the radio. Connection to the computer works, the radio itself boots with no errors, but nothing shows on the panadapter. See video attached for any help. https://youtu.be/Md3ILmdJLDI Thanks in advance for any help. Andy (NB8F) ----- NB8F - Andy Elecraft K3S - #11282 / KX2 - #1791 Elecraft owner since June 2017 Ham since March 2015 -- Sent from: http://elecraft.365791.n2.nabble.com/ ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
