Thanks Don, I decided to take a look again at the inside of the radio. Re-seated all the cards and then took the bottom off. Guess what, that single cable that attaches to the bottom of the board was disconnected, probably from when I was putting the filter in. I connected that up and all is right with the world again.
Thanks for all the help and always remember to check that cable on the bottom of the radio :) On Sun, Oct 15, 2017 at 5:31 PM, Don Wilhelm <[email protected]> wrote: > Andy, > > Do you have another receiver? If so, connect it to the K3 IF OUT. If you > hear signals, then the K3 is working fine, look at the P3 for the problem. > > OTOH, if you do not hear signals, review the work you have done - was a > cable left unplugged inside the K3 or other "silly" stuff like that. > > The IF takeoff is before the roofing filters, but the BPF3 is before the > IF takeoff. Check your work with the KBPF3 installation. > > 73, > Don W3FPR > > > On 10/15/2017 5:16 PM, NB8F wrote: > >> NOTE I have also tried removing everything in-line and just having the >> antenna, radio and P3 connected. >> >> I also tried removing the new board, but I did not try removing the 6khz >> filter. This all worked fine before today. >> > -- ------------------ NB8F Andy Holman ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
