I believe he is actually operating into an antenna on Ant1 port. He switched to Ant2 to check the port isolation and would obviously switch back to Ant1 to operate.  I doubt grounding the non-selected antenna port would make any difference on TX and some use both ports for diversity RX.  If protecting the radio is the concern then I believe as Kent stated, the dummy load would be the best option.

Mike  KI0HA


On 11/28/2017 12:01, David Gilbert wrote:

That doesn't explain how he expects the rig to short out the port for Ant 2 . .. WHEN IT HAS BEEN SELECTED ... just because there is no actual antenna connected to it.  I don't get the reasoning behind the original query.

Dave   AB7E


On 11/28/2017 7:04 AM, K9ZTV wrote:
We hook dummy loads to ANT 2 on all our K3s during FD to prevent inadvertent transmissions when no antenna is connected to it.  The ATU TUNE button is immediately above the ANT button and fat-fingered/far-sighted ops unfamiliar with the K3 have been known to hit the wrong one, especially on the higher bands where the noise floor makes it difficult to detect the absence of an antenna.

73,

Kent  K9ZTV



On Nov 28, 2017, at 7:40 AM, David Gilbert <[email protected]> wrote:


If you selected Ant 2 it wouldn't have been "unused".   How is the rig supposed to know you don't have anything physically connected to that port?

Dave   AB7E


______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]

Reply via email to