Either put a small 50 ohm load or leave it open. A short to ground may cause a PA device failure.
Bob, K4TAX Sent from my iPhone > On Nov 28, 2017, at 5:19 PM, Jim Rhodes <[email protected]> wrote: > > Well if you accidentally transmit into it an open might be better than a > short. Did you at least disable it using the utility program? > > Jim Rhodes > K0XU > >> On Nov 28, 2017 16:52, "Paul Ormandy" <[email protected]> wrote: >> >> Thanks for the replies. Hadn't thought of its use for sub rx or dummy load. >> I have grounded out the connector with a plug hooked directly to the >> receiver grounding terminal. >> >> Paul >> ______________________________________________________________ >> Elecraft mailing list >> Home: http://mailman.qth.net/mailman/listinfo/elecraft >> Help: http://mailman.qth.net/mmfaq.htm >> Post: mailto:[email protected] >> >> This list hosted by: http://www.qsl.net >> Please help support this email list: http://www.qsl.net/donate.html >> Message delivered to [email protected] >> > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
