My experience is that if you set wsjt-x to use rig control, just
starting to monitor does most of the work. I end up in Data-A
mode. This automatically sets the mic sel to Link In. I already
have a macro to open up the bandwidth, which automatically sets
the filter to my FM filter. My macro for bandwidth is :
IS 1450;BW0230;
Note that this macro doesn't open up the bandwidth to the full
4K, which I do by turning the knobs. The K3 remembers the last
bandwidth I used, so I don't have to manually change it very often.
I hope this helps.
73 Bill AE6JV
On 12/13/17 at 8:58 PM, [email protected] (RIchard
Williams via Elecraft) wrote:
Before I beat my head against the wall (or re-invent the
wheel); does someone have a micro to setup the K3S (or K3) for
WSJT-X. What I am looking for is:
1. Set the mode to TX Data
2. Set mic sel to Line In
3. Set the filter to FL2 (2.7 KHz in my case)
4. Open up the pass band width to max
I think that is it; but I might have missed something??
Thanks,
Dick, K8ZTT
-----------------------------------------------------------------------
Bill Frantz | "The only thing we have to | Periwinkle
(408)356-8506 | fear is fear itself." - FDR | 16345
Englewood Ave
www.pwpconsult.com | Inaugural address, 3/4/1933 | Los Gatos,
CA 95032
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
