Bill, Thanks for info; you know, I did not know about switching to Data A switches the input to line in. I have a AM filter, but am not sure with band with FT8 uses, what advantage a wider filter than the stock SSB filter has. Dick, K8ZTT
Sent from Yahoo Mail ohave an Android On Tue, Dec 12, 2017 at 23:09, Bill Frantz<[email protected]> wrote: My experience is that if you set wsjt-x to use rig control, just starting to monitor does most of the work. I end up in Data-A mode. This automatically sets the mic sel to Link In. I already have a macro to open up the bandwidth, which automatically sets the filter to my FM filter. My macro for bandwidth is : IS 1450;BW0230; Note that this macro doesn't open up the bandwidth to the full 4K, which I do by turning the knobs. The K3 remembers the last bandwidth I used, so I don't have to manually change it very often. I hope this helps. 73 Bill AE6JV On 12/13/17 at 8:58 PM, [email protected] (RIchard Williams via Elecraft) wrote: >Before I beat my head against the wall (or re-invent the >wheel); does someone have a micro to setup the K3S (or K3) for >WSJT-X. What I am looking for is: > 1. Set the mode to TX Data >2. Set mic sel to Line In >3. Set the filter to FL2 (2.7 KHz in my case) >4. Open up the pass band width to max >I think that is it; but I might have missed something?? >Thanks, >Dick, K8ZTT ----------------------------------------------------------------------- Bill Frantz | "The only thing we have to | Periwinkle (408)356-8506 | fear is fear itself." - FDR | 16345 Englewood Ave www.pwpconsult.com | Inaugural address, 3/4/1933 | Los Gatos, CA 95032 ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
