Chris,
To set the levels for DATA modes on Elecraft transceivers, see my
website www.w3fpr.com. Go to the bottom of the left column and click
the link.
Yes, the Elecraft transceivers are different than other radios - you
must first set the audio level to produce 4 bars with the 5th bar
flashing on the ALC meter.
73,
Don W3FPR
On 12/29/2017 4:02 PM, Chris Hallinan wrote:
Hi, Lyle.
Thanks for helping me understand the K3 even better ;)
I'm working on building a remote solution using remotehams.com software. I
hope I can use my SignaLink USB as the TX/RX audio interface to the
server. I can hear very nicely on the remote (same room still!), but the
transmit audio seems very low. Basically I've set MIC SEL to LineIn, and
selected my SignaLink USB as the audio source for the server. I'm still
experimenting with levels, etc, and that's what led to the question.
Best regards,
Chris
K1AY
On Fri, Dec 29, 2017 at 12:04 PM, Lyle Johnson <[email protected]> wrote:
Yes.
73,
Lyle KK7P
On 12/29/17 9:53 AM, Chris Hallinan wrote:
I understand that the K3 has two separate equalizer settings for CW and
SSB. I also understand it is not active in the Data modes.
However, there are four sources of audio output:
1) Internal Speaker
2) SPKRS (rear panel)
3) Phones (front panel)
4) Line Out (rear panel)
Does the equalizer operate for all four outputs?
Thanks,
Chris
K1AY
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
