Bob,
What do you mean by "Power Lock"? Will the K3 not power on? or can you
not move the POWER knob?
In either case, I would suggest you first remove all cables from the K3
except the power cable and a dummy load and see if it clears.
Did you use the latest K3 Utility to download the firmware? If not,
download K3 Utility from the ELecraft website and re-load all firmware
(you may have to "Force a Firmware Download" see manual.
If all else fails, you may have to do an EEINIT (See Reset to Factory
Defaults in the manual), and then reload the firmware.
If you had the K3 set up as you like it, hopefully you saved a
configuration (see K3 Utility). If so, you can Restore Configuration
using K3 Utility.
73,
Don W3FPR
On 2/21/2018 5:48 PM, Bob Gibson via Elecraft wrote:
I just bought a used K3 and I did a update on the rig..all seems to
go OK but I get a power lock and no output from the rig..What did I
do wrong? It was a early model and I do not believe it had a upgrade
at all. What do I need to do? 73s Bob W5RG
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
