Don,

Yes, email [email protected], or since you have the part number, you can contact sales [email protected] or phone them at 831-763-4211 to order a replacement.

To remove it, cut the plastic or otherwise push it off the pins, and then remove the pins one at a time unless you have really good desoldering tools.

73,
Don W3FPR

On 6/27/2018 9:00 PM, Don Schroder wrote:
Even a perfectionist can screw up now and then, right?

I installed P1, a 20 pin male, right angle pin connector, to the RF board, on 
the FRONT side, when the instructions clearly state
“Position 20-pin male right-angle connector P1 on the bottom of the board.” Ok, 
I can deal with the whoop-see, just
DE solder, pull it out, and install a new right-angle connector. O’boy, DE 
solder trick didn’t go so well, P1 ended up in pieces.

No problem, I have other right-angle pin connectors, just use them! But, after 
installing, the replacements are about 1/16” shorter
in length, and don’t go into J1 as far. Hello Huston, NOW we have a problem! 
The front panel is NOT getting any power!

I need a new P1, part # E620029. Other than that, the build is going great! Do 
I need to send an email to Elecraft parts department?

Comments are appreciated! Be kind, please, Thanks!

Don, KE0PVQ  (thinking about a vanity call sign, suggestions?)

Sent from Mail<https://go.microsoft.com/fwlink/?LinkId=550986> for Windows 10


______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]

Reply via email to