Lee,
As you discovered, when the USB cable is not plugged in, the USB Audio
CODEC is not shown in Device Manager. That is normal. Did I misread
something?
73,
Don W3FPR
On 6/30/2018 10:48 AM, Lee Murrah wrote:
I previously had a thread on problems I was having the internal sound card on
FT8. I was getting no output from the PC to the radio. So thinking that the
problem was how I had the internal sound card and WSJT-X set up, I switched
back to using my SignaLink, which had worked perfectly before. It worked fine
for a while, but then the failed output problem returned. Mysteriously, it
would start working again and then after a time fail again.
At one point I found that there were two USB Audio Codecs and the standard
Realtek driver associated with the speaker settings. I selected the one one
not then i use, and the output returned. Then after another failure, I found
that there was only one USB Audio Codec associated with the output.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
