Yes, I understand that, Don. My point was that when the USB cables are plugged in, something is changing or removing the drivers. One time everything works OK and the drivers are there, next time it fails and the USB drivers are gone or changed.
Lee, KV5M > On Jun 30, 2018, at 10:09 AM, Don Wilhelm <[email protected]> wrote: > > Lee, > > As you discovered, when the USB cable is not plugged in, the USB Audio CODEC > is not shown in Device Manager. That is normal. Did I misread something? > > 73, > Don W3FPR > > On 6/30/2018 10:48 AM, Lee Murrah wrote: >> I previously had a thread on problems I was having the internal sound card >> on FT8. I was getting no output from the PC to the radio. So thinking that >> the problem was how I had the internal sound card and WSJT-X set up, I >> switched back to using my SignaLink, which had worked perfectly before. It >> worked fine for a while, but then the failed output problem returned. >> Mysteriously, it would start working again and then after a time fail again. >> At one point I found that there were two USB Audio Codecs and the standard >> Realtek driver associated with the speaker settings. I selected the one one >> not then i use, and the output returned. Then after another failure, I found >> that there was only one USB Audio Codec associated with the output. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
