Without an eternal control line (inhibit), the Kenwood TX Inhibit is more like the Elecraft Test Mode (allows operation but no RF output). I'm looking for that external control. 73, ... Joe, W4TV On 2018-11-13 9:33 PM, ANDY DURBIN wrote:
"How does one implement TX Inhibit on a Kenwood TS-590?" On a TS-590S TX inhibit is menu 60. The EX command is used to change menu settings over CAT. For a TS-590S - EX06000000; reads the inhibit status EX060000001; sets TX inhibit EX060000000; clears TX inhibit For a TS-590SG the menu number is 66 so substitute 060 with 066 in the commands above. Note that, like almost all menu selections, the inhibit will only apply to the menu (A or B) in which it was set. To be safe it should be applied to both menus. Andy k3wyc ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
