I have a 6xxx K3 (not S). The output of the radio is monitored by an
LP100A wattmeter set to peak reading. The K3 drives an AL80B. I have
just done a TX power calibration. With the K3 power output set to 60
watts and running SSB I will see about 64 watts output but occasionally
see 74 watts peak on the LP100A. I am about to change to a solid state
amp and am concerned that I will damage the solid state amp by overdriving.
Is this normal behavior? If not, anything I can check, change or align?
73,
-John NI0K
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
