No, a bit paranoid perhaps but I disconnect the rig entirely, including
p/s cable. It's not too bad since I'm mostly a CW operator and don't
usually have a lot of other peripherals, SDR, computer, etc. connected
to the K3.
BTW, I don't trust the Amphenol name particularly after getting a bad
plug that wouldn't thread correctly (only realized after soldering the
thing on the coax and trying to use it. Arggh!). Amphenol is offshore
product now.
73,
Drew
AF2Z
On 02/16/19 18:24, Don Wilhelm wrote:
Drew and all,
I have changed the subject line to something more akin to the current
discussion.
Have you considered adding a coax switch? Turning to switch to an open
position (or better yet to a dummy load) when the radio is not in use
will provide protection and is a lot easier than removing the connectors.
73,
Don W3FPR
On 2/16/2019 6:07 PM, Drew AF2Z wrote:
FWIW, I use NO-OX-ID contact grease on my PL259 connectors. This
allows very tight snugging by hand, no need of wrenching.
During lightning season I frequently connect/disconnect my rig and
tuner cables. The fine film of lube on the connector threads makes a
big difference. Without it? A real PITA, not to mention wear and tear
on the the SO-239's.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
