Here comes the flames: I use slip on adapters on my PL259s that connect
my rigs/tuners/etc. to the outside world on my bulkhead. I have been
using this method for over 30 years and NEVER had a connector associated
failure. It allows for quick connect/disconnect when shutting down for
thunderstorm related issues. I use RG8X for all indoor coax duties and
run the KPA500 - so no power levels requiring heavier cable. I do snug
PL259s on equipment slightly with pliers.
Fact is, the only coax failure I have had of recent note, was the poor
quality patch cable between the P3 and K3. It was long ago replaced with
a Mil Spec cable from my junk box.
I do use a number of Daiwa 2-position coax switches for various
purposes. Any comments on coax switches?
Bill W2BLC K-Line
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
