Tony,
Hear closely - the KX3 audio shuts down if there is excessive audio
coming into the mic jack. I suspect that is what is happening.
Start over on the audio level controls with each of them set to
mid-range, and then adjust for 4 bars solid with the 5th bar flashing on
the ALC meter.
Don't forget about the POWER slider in WSJT-X. It is not a power
control at all, it is just another audio level control.
73,
Don W3FPR
On 3/15/2019 11:49 AM, Tony Estep wrote:
On Fri, Mar 15, 2019 at 9:36 AM Don Wilhelm <donw...@embarqmail.com> wrote:
...you should be using DATA A mode, and not AFSK A....
==============
Don, thanks for your comments and the info on your website. Thanks also to
the others who replied.
I am not using AFSK A mode. I never should have said anything about AFSK --
I only mentioned it to explain that the WSPR signal comes from the audio
tone generated by the software.
I have verified that I'm getting audio out of the computer and into the KX3
mic jack. The mic bias is set to off. I'm transmitting into a dummy load,
swr = 1. The meter seems to show the right display (SWR 1 bar, power 2
bars), but when I touch the mic gain knob the display goes blank. I can no
longer get the display showing the ALC, no matter what I do.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
