Dave,
Look for a post by Bob McGraw.
In brief, it takes a TEE adapter and 2 short pieces of coax. Put the
adapter between the 2 pieces of coax, and then connect one coax to ANT
OUT and the other to ANT IN. The SDR is connected to the TEE adapter.
To get output to the SDR, you must set the K3 for the RX ANT.
If you are not interested in a multi-band input to the SDR, but only the
K3 IF (for a panadapter application), then you can simply connect the
SDR to the K3 IF OUT and set the SDR to tune 8.215MHz.
In both cases, the SDR will be protected during transmit.
73,
Don W3FPR
On 4/8/2019 4:06 PM, Dave Cole (NK7Z) wrote:
A few months ago someone asked how to move the antenna signal coming in
on the main antenna connector of a K3 to an external SDR via some
connector in the rear of the K3.
The answer indicated connecting the SDR antenna to some connector in the
rear of the radio, and pressing some number of front panel keys to route
the signals from the antenna to the SDR...
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
