Hi all, I am trying to repair the son's K1 where the TX seems to be sick. (receiver sounds hot and quite nice on both bands 40/20m)
I found several C0G caps around the cores on the module board burned as same as K1 relay so I replaced them all after long time searching them on the market (EU). Now I am trying to check step by step according to manual the RF board (RF 2000 Rev.D) and I found that original builder (we did not built it) wound 5 turns of secondary T3 (green wire) instead of 4 described in manual. Should I remove the turn from T3 or is it possible to adjust the TX even with that mistake? I would like to avoid another burns... Many thanks, ----- 73 - Petr, OK1RP "Apple & Elecraft freak" B:http://ok1rp.blogspot.com G+:http://goo.gl/w3u2s9 G+: http://goo.gl/gP99xq -- Sent from: http://elecraft.365791.n2.nabble.com/ ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
