See CW QRO and TX DELAY in the menu. Also the benefits and likely
issues are described in the manual, page 58 and 66 as MENU items. As
to using other means to key the radio and amp and send CW, those may
have their own settings as required.
While I do not consider myself a high speed CW op, I do work QSK. I do
not find any truncation of the first CW element. I use the internal
keyer and either a Vibroplex Iambic paddle or a Vibroplex single level
paddle. I have VOX set to ON, CW QRO is OFF and TX DLY to NOR and 008.
Hope this helps.
73
Bob, K4TAX
On 4/24/2019 7:34 AM, Andy Durbin wrote:
"It occurs if the rising edge of the keying waveform happens at the same time as the
PTT line. The ONLY way around this is to delay the keying waveform slightly so it occurs
after the PTT."
That would seem to imply that you are not using CW VOX keying. If that is the
case then wouldn't using CW VOX eliminate the issue?
73,
Andy k3wyc
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
