Will a K3 be able to talk to the K4 remotely?
I currently use two K3's and sometimes a k3 mini and have been for 6 years.
As was mentioned two K4's will be cost prohibitive for me..
73 Dwight NS9I
On 5/21/2019 8:55 AM, Wayne Burdick wrote:
This is definitely supported by the K4 and would be a preferred way to handle
networking delays.
Wayne
N6KR
On May 21, 2019, at 6:33 AM, Andy Durbin <[email protected]> wrote:
"3) CW performance can be improved over RemoteRig. Instead of sending "dit
and dah" elements, consider sending ASCII characters or a variant where full
characters are transmitted in a data packet."
If K4 uses a super-set of K3 commands then I assume it would support KY mode (
ASCII characters transmitted over the CAT interface) for CW. I think this
mode would be a lot better known if it was supported by N1MM+ but, last time I
checked, it isn't.
73,
Andy, k3wyc
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
