>From your earlier with the tuner and amp not switching, I would connect the >cable ACC direct to the amp from the radio. If the amp switched then issue is >with the tuner. If the amp doesn't switch this points to the radio.
Recheck all of your CONFIG settings in the radio. Looks like a call to Elecraft is in order. Bob, K4TAX Sent from my iPhone > On Jun 2, 2019, at 9:31 AM, Paul Ecker <[email protected]> wrote: > > Bob - checked all the cables - all tigh and well seated. Still same problems > 73 Paul w2eck > > > > > > > > > *Paul:I would check the cables to be sure they are correctly seated > and secured for the ACC buss from the radio to the ATU and KPA500. It > maybe that the radio is not sending the commands to the ATU and then to > the KPA500.I followed the drawing in the KAT500 manual, Figure 1 on page > 5.73Bob, K4TAX* > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
