Bob - made some progress. Reverted to a KAT configuration from last year. It allows me to switch KAT to Ant 3 (160M). Additionally am use the KAT to tune on 40M and KPA is switching to 40. So last issue is to get the KAT and the KPA working on 160. So am going to do some trouble shooting on the Antenna itself and the feed line.
73 Paul w2eck On Sun, Jun 2, 2019 at 11:16 AM Bob McGraw K4TAX <[email protected]> wrote: > From your earlier with the tuner and amp not switching, I would connect > the cable ACC direct to the amp from the radio. If the amp switched then > issue is with the tuner. If the amp doesn't switch this points to the > radio. > > Recheck all of your CONFIG settings in the radio. > > Looks like a call to Elecraft is in order. > > Bob, K4TAX > > > Sent from my iPhone > > > On Jun 2, 2019, at 9:31 AM, Paul Ecker <[email protected]> wrote: > > > > Bob - checked all the cables - all tigh and well seated. Still same > problems > > 73 Paul w2eck > > > > > > > > > > > > > > > > > > *Paul:I would check the cables to be sure they are correctly seated > > and secured for the ACC buss from the radio to the ATU and KPA500. It > > maybe that the radio is not sending the commands to the ATU and then to > > the KPA500.I followed the drawing in the KAT500 manual, Figure 1 on page > > 5.73Bob, K4TAX* > > ______________________________________________________________ > > Elecraft mailing list > > Home: http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/mmfaq.htm > > Post: mailto:[email protected] > > > > This list hosted by: http://www.qsl.net > > Please help support this email list: http://www.qsl.net/donate.html > > > > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
