Dinner on Andy? Your analysis is spot on. When the KPA is requested to shut down it does some housekeeping, saving various things and putting the amp into a safe condition, including setting the 60V to off. It then sets the fan for full speed operation to bleed off the 60V power and waits for the power button to be released. It finally resets into the boot loader. It does not monitor the 60V voltage at that point. It is an interesting observation that perhaps it should, but the question is then what to do about it. The only thing really is to throw a fault, which puts that amp into a safe mode, but we are already there.
As usual, Andy, you provide great things to think about. I’m not sure there is anything to do about this one, except find out why Jerry’s 60V power is stuck on. 73 and thanks! Jack, W6FB > On Jul 14, 2019, at 4:09 PM, Andy Durbin <[email protected]> wrote: > > "the KPA500 fan was still running at a high speed even though the amp had > been turned off all night by using the front "on" button. The only way the > fan stops running is if I turn the amp on with the front switch or if I shut > the amp off by using the rear on/off switch. Menu setting for Fan is set to > normal." > > Yes, as Jack suggested, a stuck 60 V enable relay in the PSU fits the > symptoms. > > That leads to a question though - what does the firmware do if commanded to > shutdown but 60 V never bleeds down? I'm guessing it eventually times out > or else the fans should have stayed at low speed trying to bleed down the 60 > v supply. I also assuming that, when the firmware shuts down, the fan speed > control lines default to high speed setting. > > When the KPA500 is next powered, but still off, the stuck 60 v enable > provides power to the fan and the defaulted control lines make it run at high > speed. Once the firmware starts running it detects low PA temperature and > sets all fan control lines to off. > > Interesting puzzle. Was there a prize? > > 73, > Andy, k3wyc > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
