Thanks to all who sent advice ... Don (as usual) steered me in the
right direction.
I need to replace the K1 relay as I accidentally touched it when
removing the RF Board C6 capacitor for the K60XV installation. Didn't
think much at the time, but definitely bit me in the tail here.
Neil, KN3ILZ
On 8/5/2019 7:43 PM, Neil Zampella wrote:
Don,
I don't see 60M working either. I'll check these tomorrow after work.
Neil
On 8/5/2019 2:20 PM, Don Wilhelm wrote:
Neil,
Does 60 meters work, but not 40 meters?
The only things that could 40 meters to fail after installing the
K60XV are:
1) C6 is not the correct 4.7 pF value - it will be marked either 4.7
or 479.
2) Relay K1 not working properly, check the orientation and soldering.
3) P2 and/or RF J15 not installed properly.
73,
Don W3FPR
On 8/5/2019 11:14 AM, Neil Zampella wrote:
Hi all,
need some advice. I have a K2, and it was working fine. Then I put
together the K60XV option and installed it. Messed something up as
40M
Tx went away. The rig switches to Tx, but I do not see any power
coming out of the system.
---
This email has been checked for viruses by AVG.
https://www.avg.com
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
