Should have searched on Nabble first. Finally found some discussion of this PX3 cursor lag issue when running a KXPA100 back in 2017.
Elecraft apparently recognized it as a bug, and talked about a fix, but I guess nothing has been forthcoming. Grant NQ5T KX3 (8342)/KXPA100 > On Aug 18, 2019, at 7:07 PM, Brian Hunt <[email protected]> wrote: > > Just out of curiosity, is the serial speed set to 38400? Running slower > would make a difference. > > 73, > Brian, K0DTJ > >> On Aug 18, 2019, at 15:41, Grant Youngman <[email protected]> wrote: >> >> I fiddled with it a bit, and really didn’t notice any major changes in how >> the PX3 controls function. Not that there aren’t any. >> >> The simple solution is to simply set PA Mode: Off when generally tuning >> around. >> >> Grant NQ5T >> KX3 (8342)/KXPA100 >> >> >>> On Aug 18, 2019, at 5:30 PM, Donald Wines <[email protected]> wrote: >>> >>> Grant, >>> >>> Something else I've noticed since getting the KXPA100 is the Select knob on >>> the PX3 gets flaky if it's turned too fast. It seems to work fine if you >>> turn it slowly. For instance when setting the Ref Level if the Select >>> control is turned very fast the display just jitters and doesn't change the >>> level. But when turned at a very slow rate the level changes appropriately. >>> I didn't notice this behavior before I put the KXPA in line. >>> >>> You might try that and let me know what happens. >>> >>> Thanks, >>> Don, K5DW >> >> ______________________________________________________________ ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
