D36 & 37 on the RF board are;
Elecraft # E560048;
BAS70INCT Diode, 70V, SOT23 Digikey BAS70INTR-ND
On 2/22/2020 5:04 AM, Pedro, EA4KD wrote:
Thank you very much Keith and Don. Until today I haven´t had time to review
the possible failures.
I have checked and the D37 is failing so I am going to replace both D36 and
D37, what kind of diodes should I buy to replace them?
I have also checked the rest of possible and failures and everything seems
ok.
After about 100k QSO this is second fault, firts changed the pin in the back
panel about the 12 V error problem.
K3, great rig.
Pedro, EA4KD
K3 #188
-----Mensaje original-----
De: [email protected]
[mailto:[email protected]] En nombre de Keith Trinity WE6R
Enviado el: martes, 11 de febrero de 2020 1:06
Para: [email protected]
Asunto: Re: [Elecraft] K3 always 100 W
It could be D36 & 37 on the RF board. Earlier ones (1st few thousand)
had weak components. But any of them can fail and usually there is
runaway power out.
If that is not it, look for burned components under the KANT3 board
around T4 or on the underside near D36 & 37 look for burnt traces.
If it is older than about #5500, it could be front panel tin pin
oxidation, replaced them with gold.
Keith
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
