I am using the KXusb cable from computer and acc1 plug on radio but it does not connect with radio. Do I need to change the radio speed to 38400 or is it automatic? If so looked in manual and did not see how Bill
> On April 2, 2020 at 11:54 AM Jack Brindle <[email protected] > mailto:[email protected] > wrote: > > > The utility is telling you that it is communicating with your KX3 at > 38400 bits/sec. The KX3 has firmware revision 2.90. > This is not an error message. It appears to be working just fine. > > 73! > Jack, W6FB > > > > On Apr 2, 2020, at 9:41 AM, 1lasportsman 1lasportsman > <[email protected] mailto:[email protected] > wrote: > > > > I am trying to use the utility to see radio > > > > I am getting this error message > > > > KX3 MCU revision 02.90 rs232 speed 38400 bit/s > > > > IT worked before but I get this now > > > > any ideas the radio works fine but no utility with computer .I > > tried this on 2 computers same error. > > > > Bill > > > > WF9m > > ______________________________________________________________ > > Elecraft mailing list > > Home: http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/mmfaq.htm > > Post: mailto:[email protected] > > mailto:[email protected] > > > > This list hosted by: http://www.qsl.net > > Please help support this email list: http://www.qsl.net/donate.html > > Message delivered to [email protected] mailto:[email protected] > > > > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
