Thanks for your help as always. Well frankly I have been calling it
the wrong thing forever.
Rich
On 4/6/2020 14:09 PM, Don Wilhelm wrote:
Rich,
Well, since the KPA100 is an option for the K2 (and not for any other
transceiver), I did not make a typo.
Since you have the K3S, the 100 watt amplifier is the KPA3.
That is why one has to be careful when specifying designations of
options.
As I recall, that distorted audio on the K3S is a symptom of a failure
in the LPA on the RF Board. Contact [email protected] to get some
points to check.
73,
Don W3FPR
On 4/6/2020 1:43 PM, Rich wrote:
Just to make sure that was a typo you said K2??
I did your test on my K3S and I am getting about 55 watts on the meter
Any other ideas?
Thank you so much
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
