I just wired an XLR to the 8 pin MIC connector via a 2 conductor
shielded cable and be done with it. I hate adapters due to the high
likelyhood of intermittent connections.
XLR pin #1 to 8 pin #7 Shield
XLR pin #2 to 8 pin #1 mic hi
XLR pin #3 to 8 pin #8 mic lo
Be sure BIAS is turned off if using a dynamic mike.
73
Bob, K4TAX
On 5/11/2020 4:32 PM, Tony wrote:
All:
I'd like to connect an XLR mic cable that has a 1/4 inch TRS plug to
my K3S. It seems the only way to do that is wire a female 1/4 inch TRS
to an 8-pin mic connector.
It would be easier to use a 1/4 to 1/8th inch adapter and connect
through the rear mic input, but I don't believe it accommodates
balanced mics?
Thanks,
Tony
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
