Don, You are so correct and most of us who have built them are all to framiliar with the process. Since Mark is going to use a Kenwood microphone there might not be any need to pull the front panel, just the control board. (Unless the builder soldered the jumpers.) Taking a leap of faith, it should (hopefully) be just pulling off the existing header and jumpering across the pins with standard jumpers that are available at Radio Shack everywhere. Regards, Joe N9JR
----- Original Message ---- From: Don Wilhelm <[EMAIL PROTECTED]> To: Mark <[EMAIL PROTECTED]>; [email protected] Sent: Friday, June 30, 2006 1:33:39 PM Subject: RE: [Elecraft] K2/100SSB partial disassembly/assembly help Mark, OK, there needs to be a document 'How to disassemble your K2' for those who purchased the K2 already built. Sure the instructions are there in the manual, but they are spread out over the entire manual since that is something that is learned in pieces during the build process. _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
