The setting for the PA module is probably re-set to NOT INSTALLED.
73, Alan. G4GNX ------ Original Message ------ From: "Bill DeVore" <[email protected]> To: [email protected] Sent: 26/07/2020 20:39:51 Subject: [Elecraft] K3S in QRP mode
I recently did a Parameter Initialization on my K3S. I didn’t save the current firmware configuration as I’ve never done any custom programming on the radio. After performing the initialization, a full rotation of the Power knob only goes from 0 to a maximum of 12 w on any band. Prior to the initialization of the rig, I could adjust power all the way to a max of 110w on each band. Did the initialization set the rig in QRP mode? I sure hope there’s a configuration menu somewhere that I can change to get the radio back to full power. Bill - W3PNM ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
