Check that the KPA3 is turned on to "nor" in the config menu. (Just don't ask me how I know.)
On Sun, Jul 26, 2020 at 2:41 PM Bill DeVore <[email protected]> wrote: > I recently did a Parameter Initialization on my K3S. I didn’t save the > current firmware configuration as I’ve never done any custom programming on > the radio. > > After performing the initialization, a full rotation of the Power knob > only goes from 0 to a maximum of 12 w on any band. Prior to the > initialization of the rig, I could adjust power all the way to a max of > 110w on each band. > > Did the initialization set the rig in QRP mode? I sure hope there’s a > configuration menu somewhere that I can change to get the radio back to > full power. > > Bill - W3PNM > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] -- Jim K0XU [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
