On 7/28/20 at 12:21 PM, [email protected] (Bill DeVore) wrote:
Make sure you save a current config file before doing anything
as DRASTIC as an EERint.
Note that saved config files may be poisoned. Here's an email I
meant to send to the list, but ended up just sending to NR4C:
I had a problem with the mw Transmitter Gain calibration. It
kept saying it read 2.07 mw when it should have been 1.00 mw.
I went through a bunch of suggestions from support, which ended
in EEINIT. That, and a manual reconfiguration of the radio to
include the 100W amp, tuner, and USB computer interface let me
run the transmitter gain calibration successfully from the
utility. THANKS ELECRAFT SUPPORT.
I then went back and reloaded old saved configurations. I had to
go back about 5 of them, to 2017, to get one that would let me
run the Transmitter Gain calibration without error.
Doing the may have had some benefit in letting me being able to
checkin to the 20M and 40M Elecraft SSB nets. That's hard to
tell, but conditions today were pretty bad.
73 Bill AE6JV
On 7/26/20 at 5:48 PM, [email protected] (Nr4c) wrote:
I don’t know why owners jump to a EEINIT to solve problems.
There are less distructive ways. Starting with restoring a
saved good CONFIG file
-----------------------------------------------------------------------
Bill Frantz | If the site is supported by | Periwinkle
(408)348-7900 | ads, you are the product. | 150
Rivermead Road #235
www.pwpconsult.com | |
Peterborough, NY 03458
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
